[MST1407]

Good day kowalmisiek,
Sorry fo the delay but my colleagues at support will always try to reply asap, This normally means you will get a reply the same day or within 24 hours, however they do not work on the weekend.

[MST1407]

please do 🙂

[MST1407]

very welcome

[MST1407]

did you try doing that with AMD Overdrive software ?
http://www.amd.com/en/technologies/amd-overdrive

[MST1407]

thanks

[MST1407]

passive adapters

[MST1407]

i am quite sure it is because the MST Hub is still powered and the screens will see it and therefor not turn off. The adapter most probably prevents the screen from being able to “see” the MST Hub. At home I plugged the Adapter from the MST Hub into same Power Block as the screens and I just run off the power block … then everything turns off for sure 🙂

[MST1407]

Hello Hadog,

IF your MST Hub ahs HDMI outputs than you have the CSV-5300H.
And no then you would not need adapters, just normal passive HDMI Cables to go to Screens.

[MST1407]

Good day miKL,

The CSV-2000H uses the same driver as its succesor the CSV-2300H.
You cna find latest WIN drivers here:
http://www.club-3d.com/en/openpdfz/2395_1/zip/displaylink_sw_win10_81_7_version_8.4_m0.zip/

[MST1407]

that is indeed not a good sign.
And when you clock down the memory it is ok, exept you cannot do that anymore with new drivers ? Did i get that correct ?

[MST1407]

Hi dabwolf, welcome 🙂

[MST1407]

Hello Hadog,

An MST Hub is an active device so you should use passive adaters plus normal HDMI cable that comes with the screens, to connect your HDMI Monitors.
Like these: CAC-1001
http://www.club-3d.com/en/detail/2373/displayport_to_hdmi_passive_adapter/

Any particular reason you choose for the CSV-5300A instead of the CSV-5300H ?

[MST1407]

Screens turning off in an Mulit Screen / Eyefinity Setup is highly dependent on the screens. 
We did not test with Terra Screens, but i do know that for instance our Eyfinity 6 setup with 6 x Samsung 22″ screens also does not turn off automatically.
Please check for latest software for the screens and even if there is a drvier available for the screens to install on your system.

[MST1407]

Hi Fortress66,
The default memory speed for the CGAX-R9298SO is actually 1350 MHz.
If your screen turns black after a few minutes, it is most probably due to temperature getting too high. Please check temperature of the Card.
Sometimes it will help to replace the Cooling Paste in between the GPU/Card and the Cooler/Heatsink. Over time that cooling paste can dry out and therfor work less efficient.
With regards to the option that the AMD driver will (or not) give you i really cannot help you. For that you would need to contact AMD.

[MST1407]

Good day Pedro, yes it does support 1920×1080 up to 120Hz.

[Author]

Posts