Possible solution to artifacts and flickering CAC-1070/1170

Updated on 28-02-2017 in Adapters and Cables
2 on 05-10-2016

Hello everyone!

after some mailing with the support team from CLUB3D and many changes to the pixelclock of the monitor
all the way from 538 to 593 i was still getting errors with 58-60hz and some firmware updates to the adapter..

the only way for me to be “problem-free” from these issues was to lower the HZ to 54.444 and the pixelclock to 539 – voila – all my problems were gone but i got a new problem – it was not running in 60hz…

So – i downloaded MonInfo after seeing someone else using to to find out their timings and if their monitor was able to do CVT-Reduced Blanking etc etc – i noticed it stating that my NATIVE pixel clock was 600mhz…

i did not put much weight to this as i thought it was just a Maximum possible reported pixelclock…

i later changed pixel clock to 600mhz, all the artifacts and the flickering was gone however i was no longer getting 4:4:4 chroma, i believe it to be because of the monitor working in 61hz and not 60hz per spec..

so – does anyone know a way to have 60hz and 600mhz pixelclock?

 
  • Liked by
Reply
0 on 05-10-2016

highest i have gotten to atm is 575mhz which is 58.080hz which is able to do 4:4:4 without artifacts and flickering but i would love to get that 60hz!

  • Liked by
Reply
Cancel
0 on 28-02-2017

What video adapter and OS are you using?

  • Liked by
Reply
Cancel